Item # RF19-1308 &1308A, Valve Stems On Sterling Process Equipment and Services, Inc.

Rubber Fab Technologies Group has successfully met our customer’s goals with quality products that meet the highest sanitary standards and purity criteria. Our hygienic seals have provided superior surface finish and elastomer purity for use in production facilities of fine pharmaceutical, biotechnology, high-purity water, injectables, food and beverage products. In fact, Rubber Fab has made much significant advancement in gasket materials and manufacturing over the past few years and has recently applied this knowledge to the production of our Component Parts for pumps, valves, fillers and system equipment.

Rubber Fab has made the same commitment to purity and excellence in the manufacturing of our Component Parts as we have our line of hygienic seals. Like our other products, our component parts are color coded for material identification and come with lot and batch numbers that provided traceability at all times.

If it’s valve stems and balls, centrifugal pump parts and kits or filler parts, you can be assured of our continuous commitment for a superior product. Rubber Fab Technologies Group will meet your requirements and your expectations.

Valve Stems and Balls:

New and exchange Valve Stems
Check Valve Replacement Balls
PTFE enhanced
Superior surface finishes
Available in Buna, EPDM and FKM
FDA and 3A compliant
All stem varieties are available:
compression, divert and shut-off

Centrifugal Pump Kits for:

114, 216 & 218/328 pumps
Available in Buna, EPDM and FKM elastomers

Centrifugal Pump Parts:

Backplates
Carbon seals
Casing gaskets & O-Rings
Silicon carbide seals
Cups
Springs
Stub shafts
Impeller pins

Filler Parts:

Rolling diaphragms
Vacuum cups
Suction cups
U-cups
Screens
Perforated plates
O-Rings
Gaskets
Couplings

Metal Detectable Elastomers

Another major material advancement from Rubber Fab Technologies Group is in the area of metal detectable elastomers.

A common problem with component and filler parts is wear and tear. When rubber breaks off it can migrate through your system and into your product. Searching for and locating fragmented rubber parts is a costly, time consuming and inconclusive process requiring expensive x-ray equipment, manual observation and an extensive maintenance program. Not locating a worn rubber piece can have an even costlier outcome.

Rubber Fab provides an easier and cost effective solution with metal detectable elastomers. By manufacturing any standard elastomer with a 3A, FDA approved metal filler, a worn off piece of elastomer material can now be located by an in-line metal detector. This alarm enables your system to instantly be shut down for the removal of contaminated product and the immediate replacement of the worn part. Detectables eliminate product recall, lowers product loss and decreases the risk of elastomers consumed in finished product.

Detectables are available in Buna, EPDM, FKM and Silicone materials and are available in sanitary gaskets, cam lock gaskets, valve stems, check balls, o-rings and almost any molded products.